Search results
Results From The WOW.Com Content Network
The t-test p-value for the difference in means, and the regression p-value for the slope, are both 0.00805. The methods give identical results. This example shows that, for the special case of a simple linear regression where there is a single x-variable that has values 0 and 1, the t-test gives the same results as the linear regression. The ...
Statistical tests are used to test the fit between a hypothesis and the data. [1] [2] Choosing the right statistical test is not a trivial task. [1]The choice of the test depends on many properties of the research question.
In null-hypothesis significance testing, the p-value [note 1] is the probability of obtaining test results at least as extreme as the result actually observed, under the assumption that the null hypothesis is correct. [2] [3] A very small p-value means that such an extreme observed outcome would be very unlikely under the null hypothesis.
Linear regression can be used to estimate the values of β 1 and β 2 from the measured data. This model is non-linear in the time variable, but it is linear in the parameters β 1 and β 2; if we take regressors x i = (x i1, x i2) = (t i, t i 2), the model takes on the standard form
Note that a p-value of 0.01 suggests that 1% of the time a result at least that extreme would be obtained by chance; if hundreds or thousands of hypotheses (with mutually relatively uncorrelated independent variables) are tested, then one is likely to obtain a p-value less than 0.01 for many null hypotheses.
The binomial distribution is the basis for the p-chart and requires the following assumptions: [2]: 267 The probability of nonconformity p is the same for each unit; Each unit is independent of its predecessors or successors; The inspection procedure is the same for each sample and is carried out consistently from sample to sample
If there is interest in the marginal probability of obtaining a tail, only the number T out of the 100 flips that produced a tail needs to be recorded. But T can also be used as a test statistic in one of two ways: the exact sampling distribution of T under the null hypothesis is the binomial distribution with parameters 0.5 and 100.
A paired difference test is designed for situations where there is dependence between pairs of measurements (in which case a test designed for comparing two independent samples would not be appropriate). That applies in a within-subjects study design, i.e., in a study where the same set of subjects undergo both of the conditions being compared.