Ads
related to: amc 20 rear axle bearing retainer
Search results
Results From The WOW.Com Content Network
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps.
The Iron Duke I4 used by AMC in Jeeps from 1980 to 1983 used the standard small block Chevrolet bolt pattern bell housing. The later (1984-02) AMC I4 had the GM 60 degree V6/I4 bolt pattern, and this was retained for the life of the engine. AMC often used lighter duty transmissions with the four cylinder engines.
Axle tooling equipment – Sold in 1985 to Dana Holding Corporation, and they named the AMC-15 axles as Dana 35. [203] Dana manufactured the AMC-20 axles for AM General 's Hummer H1 . The company also continues to produce the AMC-15 axle; however, they have been upgraded from American Motors' original design with multiple variations (including ...
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep
A worn, damaged, or lost retainer would allow the door to swing outward, fail to engage the rubber stop on the rear bumper, and slide entirely off the channel (and the vehicle). A single, hinged rear door gave access to the cargo area from the floor to the bottom of the hard top, and the door was the width of the open area between the wheel wells.
The Nash Rambler engine is a family of straight-six engines that were produced by Nash Motors and then American Motors Corporation (AMC), and used in Nash, Rambler, and AMC passenger cars from 1940 through 1965. It was succeeded by the AMC straight-6 engine in 1964, a completely new design. The engine evolved in several displacements and was ...