Search results
Results From The WOW.Com Content Network
The basic converter box is passive and does not communicate back to the carrier. It simply tunes to one of the channels being transmitted together over the wire and re-transmits it to a television or other video device on a standard broadcast frequency (usually a customer-selected, locally unused frequency between VHF 2 and 4).
A continuity tester is an item of electrical test equipment used to determine if an electrical path can be established between two points; [1] that is if an electrical circuit can be made. The circuit under test is completely de-energized prior to connecting the apparatus.
The test often reveals problems that occurred during assembly, such as defective components, improper component placement, and insulator defects that may cause inadvertent shorting or grounding to chassis, in turn, compromising electrical circuit quality and product safety. [2]
In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker ) across the chosen path.
An autoranging digital multimeter can automatically adjust the scaling network so the measurement circuits use the full precision of the A/D converter. In a digital multimeter the signal under test is converted to a voltage and an amplifier with electronically controlled gain preconditions the signal.
A typical modern set-top box, along with its remote control - pictured here a digital terrestrial TV receiver by TEAC. A set-top box (STB), also known as a cable box, receiver, or simply box, and historically television decoder or a converter, [1] is an information appliance device that generally contains a TV tuner input and displays output to a television set, turning the source signal into ...
Megohmmeter M1101M. A Megohmmeter or insulation resistance tester, is a special type of ohmmeter used to measure the electrical resistance of insulators. [1] Insulating components, for example cable jackets, must be tested for their insulation strength at the time of commissioning and as part of maintenance of high voltage electrical equipment and installations.
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.