Search results
Results From The WOW.Com Content Network
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
ip addr, ip link: Address and link configuration route: ip route: Routing tables arp: ip neigh: Neighbors iptunnel: ip tunnel: Tunnels nameif, ifrename: ip link set name: Rename network interfaces ipmaddr: ip maddr: Multicast netstat: ss, ip route: Show various networking statistics brctl: bridge: Handle bridge addresses and devices
BIRD (recursive acronym for BIRD Internet Routing Daemon [2]) is an open-source implementation for routing Internet Protocol packets on Unix-like operating systems. It was developed as a school project at the Faculty of Mathematics and Physics, Charles University, Prague, [3] and is distributed under the GNU General Public License.
eth0 is the interface name of the network interface card representing an Ethernet port. ppp0 is a PPPoE interface, which is configured as the default route in this example. A default route is recognized by the destination 0.0.0.0 and the flag G. A network router is identified by the network mask 255.255.255.255 and the flag H.
Many Linux distributions have deprecated the use of ifconfig and route in favor of the software suite iproute2, such as ArchLinux [3] or RHEL since version 7, [4] which has been available since 1999 for Linux 2.2. [5] iproute2 includes support for all common functions of ifconfig(8), route(8), arp(8) and netstat(1). It also includes multicast ...
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.
For example, the U flag indicates that an IP route is up. filtering criteria: Access-control lists associated with the route; interface: Such as eth0 for the first Ethernet card, eth1 for the second Ethernet card, etc. Shown below is an example of what the table above could look like on a computer connected to the internet via a home router:
It is also possible to configure Linux networking ad-hoc using the ip command from the iproute2 package. The following command can be used to configure the route using ip : [ 10 ] root@router:~# ip route add 10 .10.20.0/24 via 192 .168.100.1