Search results
Results From The WOW.Com Content Network
nslookup operates in interactive or non-interactive mode. When used interactively by invoking it without arguments or when the first argument is - (minus sign) and the second argument is a hostname or Internet address of a name server, the user issues parameter configurations or requests when presented with the nslookup prompt (>).
The following example uses getaddrinfo() to resolve the domain name www.example.com into its list of addresses and then calls getnameinfo() on each result to return the canonical name for the address. In general, this produces the original hostname, unless the particular address has multiple names, in which case the canonical name is returned ...
Hex Protocol Number Keyword Protocol References/RFC; 0x00 0 HOPOPT IPv6 Hop-by-Hop Option: RFC 8200: 0x01 1 ICMP Internet Control Message Protocol: RFC 792: 0x02 2 IGMP Internet Group Management Protocol: RFC 1112: 0x03 3 GGP Gateway-to-Gateway Protocol: RFC 823: 0x04 4 IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream ...
Addresses can also be entered in a single argument. {{blockcalc|Any text that includes IPv4 and/or IPv6 addresses.}} Addresses are extracted from the arguments, so any text can be used. {{blockcalc|1=Any text with = that includes IPv4 and/or IPv6 addresses.}} Use 1= if the text contains "=". The following optional parameters can be used. |ok
The Address Resolution Protocol (ARP) is a communication protocol for discovering the link layer address, such as a MAC address, associated with a internet layer address, typically an IPv4 address. The protocol, part of the Internet protocol suite , was defined in 1982 by RFC 826 , which is Internet Standard STD 37.
The original list of IPv4 address blocks was published in September 1981. [3] In previous versions of the document, [19] [20] network numbers were 8-bit numbers rather than the 32-bit numbers used in IPv4. At that time, three networks were added that were not listed earlier: 42.rrr.rrr.rrr, 43.rrr.rrr.rrr, and 44.rrr.rrr.rrr.
SSM destination addresses must be in the ranges 232.0.0.0/8 for IPv4. For IPv6 current allowed SSM destination addresses are specified by ff3x::/96, where the hexadecimal digit x represents the scope. [1] Note however that the allocation may be extended in the future so receivers and network equipment should treat any ff3x::/32 address as SSM. [2]
IPv4 address 224.0.0.251 or IPv6 address ff02::fb; UDP port 5353; When using Ethernet frames, the standard IP multicast MAC address 01:00:5E:00:00:FB (for IPv4) or 33:33:00:00:00:FB (for IPv6) The payload structure is based on the unicast DNS packet format, consisting of two parts—the header and the data. [5]