Ad
related to: 100 amp hour to kwh meter bulb conversion
Search results
Results From The WOW.Com Content Network
All the SI prefixes are commonly applied to the watt-hour: a kilowatt-hour (kWh) is 1,000 Wh; a megawatt-hour (MWh) is 1 million Wh; a milliwatt-hour (mWh) is 1/1,000 Wh and so on. The kilowatt-hour is commonly used by electrical energy providers for purposes of billing, since the monthly energy consumption of a typical residential customer ...
For example, when a light bulb with a power rating of 100 W is turned on for one hour, the energy used is 100 watt hours (W·h), 0.1 kilowatt hour, or 360 kJ. This same amount of energy would light a 40-watt bulb for 2.5 hours, or a 50-watt bulb for 2 hours.
DC meters often measured charge in ampere hours. Since the voltage of the supply should remain substantially constant, the reading of the meter was proportional to actual energy consumed. For example, if a meter recorded that 100 ampere hours had been consumed on a 200-volt supply, then 20 kilowatt-hours of energy had been supplied. A 'Reason ...
Energy (system unit unit-code symbol or abbrev. notes sample default conversion combination output units SI: gigajoule: GJ GJ 1.0 GJ (280 kWh) megajoule: MJ MJ 1.0 MJ (0.28 kWh)
Electric power is the rate of transfer of electrical energy within a circuit.Its SI unit is the watt, the general unit of power, defined as one joule per second.Standard prefixes apply to watts as with other SI units: thousands, millions and billions of watts are called kilowatts, megawatts and gigawatts respectively.
kilowatt-hours per 100 kilometers: MJ/km kWh/mi: Kilowatt-hour: kWh/100 mi: kW⋅h/100 mi: 22.3694: kilowatt-hour per 100 miles: kilowatt-hours per 100 miles: mpge: Miles per gallon gasoline equivalent: MJ/100 km: MJ/100 km: 10: megajoule per 100 kilometres: megajoules per 100 kilometres: megajoule per 100 kilometers: megajoules per 100 ...
MSP kWh is the amount of electricity consumed at the 'meter supply point', which is the customer's meter. GSP kWh is obtained by multiplying the MSP kWh by the Line Loss Factor (LLF, a figure > 1) to include the amount of electricity lost when it is conducted through the distribution network, from the 'grid supply point' to the customer's meter.
The power setting displays instantaneous power, and the kilowatt-hour setting displays energy consumed since last reset. When electricity is disconnected, the P4400's measurements and meters are reset. [6] To reset Kill A Watt models that store values, press Volt and Amp together, or press the Reset key in some models.