Search results
Results From The WOW.Com Content Network
In electric power systems and industrial automation, ANSI Device Numbers can be used to identify equipment and devices in a system such as relays, circuit breakers, or instruments. The device numbers are enumerated in ANSI / IEEE Standard C37.2 Standard for Electrical Power System Device Function Numbers, Acronyms, and Contact Designations .
A US National Electrical Code rule for the number of circuits in a panel board. clamp meter An ammeter that measures current with a split core that can be clamped on a wire. Clapp oscillator An electronic oscillator circuit that uses three capacitors and an inductor. class of accuracy in electrical measurements
The electrical arrangement of valve arms and other components essential for the function of the main power circuit of a converter. converter section of a double converter That part of a double converter in which the main direct current when viewed from the DC terminals always flows in the same direction. controllable valve device
The IEEE 315 standard contains a list of Class Designation Letters to use for electrical and electronic assemblies. For example, the letter R is a reference prefix for the resistors of an assembly, C for capacitors, K for relays. Industrial electrical installations often use reference designators according to IEC 81346.
Air-actuated control valves each with a 4–20 mA "I to P" converter integral to a valve positioner. In this example each positioner is comparing the valve steam travel against control signal, and applying any correction. The opening or closing of automatic control valves is usually done by electrical, hydraulic or pneumatic actuators. Normally ...
EWMP – earthworks/electrical works/excavation works management plan; EWR – end-of-well report; EXL – or XL, exploration licence (United Kingdom), a type of onshore licence issued between the first onshore licensing round (1986) and the sixth (1992) EXP – exposed; EZSV – easy sliding valve (drillable packer plug)
r(t) is the desired process variable (PV) or setpoint (SP), and y(t) is the measured PV. The distinguishing feature of the PID controller is the ability to use the three control terms of proportional, integral and derivative influence on the controller output to apply accurate and optimal control. The block diagram on the right shows the ...
A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing. One corporation can have many CAGE codes, as can one government, because each division, department, and site (campus) can have its own CAGE code.