Ad
related to: 0.15 length in inches on a number system is measured in terms of two
Search results
Results From The WOW.Com Content Network
A unit of measurement, or unit of measure, is a definite magnitude of a quantity, defined and adopted by convention or by law, that is used as a standard for measurement of the same kind of quantity. [1] Any other quantity of that kind can be expressed as a multiple of the unit of measurement. [2] For example, a length is a physical quantity.
Wine was measured with units based on the wine gallon of 231 cubic inches (3.785 L), beer was measured with units based on an ale gallon of 282 cubic inches (4.621 L) and grain was measured with the Winchester measure with a gallon of approximately 268.8 cubic inches (one eighth of a Winchester bushel or 4.405 L). In 1824, these units were ...
45,600 has 3, 4 or 5 significant figures depending on how the last zeros are used. For example, if the length of a road is reported as 45600 m without information about the reporting or measurement resolution, then it is not clear if the road length is precisely measured as 45600 m or if it is a rough estimate.
For example, a length that is significantly longer or shorter than 1 metre can be represented in units that are a power of 10 or 1000 metres. This differs from many older systems in which the ratio of different units varied. For example, 12 inches is one foot, but the larger unit in the same system, the mile is not a power of 12 feet. It is ...
Below NPS14, the NPS number is not consistent with the pipe diameter in inches. Copper tubing, however, is measured in nominal size, 1 ⁄ 8 inch less than the outside diameter. The Schedule system is used for standard pipe thicknesses. Alcohol content is frequently given in proof, 2 × percent alcohol by volume; The cord is used for volume of ...
Subtension refers to the length between two points on a target, and is usually given in either centimeters, millimeters or inches. Since an mrad is an angular measurement, the subtension covered by a given angle (angular distance or angular diameter) increases with viewing distance to the target. For instance the same angle of 0.1 mrad will ...
It is especially popular as a unit of measurement with shooters familiar with the imperial measurement system because 1 MOA subtends a circle with a diameter of 1.047 inches (which is often rounded to just 1 inch) at 100 yards (2.66 cm at 91 m or 2.908 cm at 100 m), a traditional distance on American target ranges.
Parts-per notations may be expressed in terms of any unit of the same measure. For instance, the expansion coefficient of some brass alloy, α = 18.7 ppm/°C, may be expressed as 18.7 (μm/m)/°C, or as 18.7 (μ in/in)/°C; the numeric value representing a relative proportion does not change with the adoption of a different unit of length.