Ad
related to: lh2 density kg m3 table of elements and properties
Search results
Results From The WOW.Com Content Network
Liquid hydrogen (H 2 (l)) is the liquid state of the element hydrogen. Hydrogen is found naturally in the molecular H 2 form. [4] To exist as a liquid, H 2 must be cooled below its critical point of 33 K. However, for it to be in a fully liquid state at atmospheric pressure, H 2 needs to be cooled to 20.28 K (−252.87 °C; −423.17 °F). [5]
The following molar volumes and densities for the majority of the gaseous elements were calculated from the van der Waals equation of state, using the quoted values of the van der Waals constants. The source for the van der Waals constants and for the literature densities was: R. C. Weast (Ed.), Handbook of Chemistry and Physics (53rd Edn ...
Energy densities table Storage type Specific energy (MJ/kg) Energy density (MJ/L) Peak recovery efficiency % Practical recovery efficiency % Arbitrary Antimatter: 89,875,517,874: depends on density: Deuterium–tritium fusion: 576,000,000 [1] Uranium-235 fissile isotope: 144,000,000 [1] 1,500,000,000
This is a list of chemical elements and their atomic properties, ordered by atomic number (Z). Since valence electrons are not clearly defined for the d-block and f-block elements, there not being a clear point at which further ionisation becomes unprofitable, a purely formal definition as number of electrons in the outermost shell has been used.
J.A. Dean (ed.), Lange's Handbook of Chemistry (15th Edition), McGraw-Hill, 1999; Section 6, Thermodynamic Properties; Table 6.4, Heats of Fusion, Vaporization, and Sublimation and Specific Heat at Various Temperatures of the Elements and Inorganic Compounds
J.A. Dean (ed), Lange's Handbook of Chemistry (15th Edition), McGraw-Hill, 1999; Section 6, Thermodynamic Properties; Table 6.3, Enthalpies and Gibbs Energies of Formation, Entropies, and Heat Capacities of the Elements and Inorganic Compounds
Since the bulk density of a solid chemical element is strongly related to its molar mass (usually about 3R per mole, as noted above), there exists noticeable inverse correlation between a solid's density and its specific heat capacity on a per-mass basis. This is due to a very approximate tendency of atoms of most elements to be about the same ...
Chemical storage could offer high storage performance due to the high storage densities. For example, supercritical hydrogen at 30 °C and 500 bar only has a density of 15.0 mol/L while methanol has a hydrogen density of 49.5 mol H 2 /L methanol and saturated dimethyl ether at 30 °C and 7 bar has a density of 42.1 mol H 2 /L dimethyl ether.