Ads
related to: 4 inch rubber suction hose for toilet seat
Search results
Results From The WOW.Com Content Network
For the common plunger, the cup is pushed down against the drain opening, either pressing hard into the drain to force air in or pushing down until the rubber cup is flattened. The cup is then pulled out, creating a vacuum to pull blockage material upward and dislodge waste or other material.
5-inch (13 cm) flex suction hose with Storz fittings, mounted on an engine. Flexible suction hose (Flex suction or suction hose), not to be confused with hard suction hose in U.S., is a specific type of fire hose used in drafting operations, when a fire engine uses a vacuum to draw water from a portable water tank, pool, or other static water source.
Suction Hose. Suction hose is laid down on the suction side of pump (inlet) where the water passing through it is at a pressure either below or above that of the atmosphere. It is designed to resist internal and external pressure. It should have sufficient strength to withstand the pressure of external air when a vacuum has formed inside.
If the toilet is flushed from a tank, a large holding cistern is mounted above the toilet, containing approximately 4.5 to 6 L (1.2 to 1.6 US gallons) of water in modern designs. This tank is built with a large drain 50 to 75 mm (2 to 3 inches) diameter hole at its bottom covered by a flapper valve that allows the water to rapidly leave the ...
A hose is a flexible hollow tube or pipe designed to carry fluids from one location to another, often from a faucet or hydrant. [ 1 ] Early hoses were made of leather, although modern hoses are typically made of rubber, canvas, and helically wound wire.
A pit latrine, also known as pit toilet, is a type of toilet that collects human waste in a hole in the ground. [2] Urine and feces enter the pit through a drop hole in the floor, which might be connected to a toilet seat or squatting pan for user comfort. [ 2 ]
Screw clamps are normally used for hoses 1/2 inch diameter and up, with other clamps used for smaller hoses. The first patent for a worm-drive hose clamp was granted to Swedish inventor Knut Edwin Bergström [ se ] in 1896 [ 1 ] Bergström founded “Allmänna Brandredskapsaffären E. Bergström & Co.” in 1896 (ABA) to manufacture these worm ...
Rubber hose or Rubberhose may refer to: A hose, a flexible hollow tube; Rubber hose animation, the first animation style that became standardized in the American animation industry; Rubberhose (file system), a deniable encryption archive containing multiple file systems whose existence can only be verified using the appropriate cryptographic key