Ads
related to: cisco inter switch link to usb 2.0 port identification
Search results
Results From The WOW.Com Content Network
Cisco Inter-Switch Link (ISL) is a Cisco proprietary link layer protocol that maintains VLAN information in Ethernet frames as traffic flows between switches and routers, or switches and switches. [1] ISL is Cisco's VLAN encapsulation protocol and is supported only on some Cisco equipment over the Fast and Gigabit Ethernet links. It is offered ...
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.
The link joining of two Fibre Channel switches through E_ports Cisco Inter-Switch Link (ISL) is a proprietary protocol that maintains VLAN information as traffic flows between switches and routers. Topics referred to by the same term
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
InterSwitch Trunk (IST) is one or more parallel point-to-point links (Link aggregation) that connect two switches together to create a single logical switch.The IST allows the two switches to share addressing information, forwarding tables, and state information, permitting rapid (less than one second) fault detection and forwarding path modification.
High-Speed Inter-Chip (HSIC) is a chip-to-chip variant of USB 2.0 that eliminates the conventional analog transceivers found in normal USB. It was adopted as a standard by the USB-IF in 2007. The HSIC physical layer uses about 50% less power and 75% less board area compared to traditional USB 2.0. HSIC uses two signals at 1.2 V and has a ...
The written USB 3.0 specification was released by Intel and its partners in August 2008. The first USB 3.0 controller chips were sampled by NEC in May 2009, [4] and the first products using the USB 3.0 specification arrived in January 2010. [5] USB 3.0 connectors are generally backward compatible, but include new wiring and full-duplex operation.
For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.