Search results
Results From The WOW.Com Content Network
A guide to the recoil from the cartridge, and an indicator of bullet penetration potential. The .30-06 Springfield (at 2.064 lbf-s) is considered the upper limit for tolerable recoil for inexperienced rifle shooters. [2] Chg: Propellant charge, in grains; Dia: Bullet diameter, in inches; BC: Ballistic coefficient, G1 model; L: Case length (mm)
The specified maximum diameter of an unfired .50 BMG bullet is 0.510-inch (13.0 mm); while this appears to be over the .50 inch (12.7 mm) maximum allowed for non-sporting Title I firearms under the U.S. National Firearms Act, the barrel of a .50 BMG rifle is only .50 inch (12.7 mm) across the rifling lands and slightly larger in the grooves ...
The .50-90 Sharps is similar to the .50-100 Sharps and .50-110 Sharps cartridges. All three use the same 2.5-inch (64 mm) case, the latter two being loaded with more grains of black powder. All rifles made for the .50-90 Sharps should be able to use the .50-110 and .50-100 cartridges due to the case dimensions being nearly identical.
.22 Long Rifle.22 Extra Long.22 Remington Automatic.22 Winchester Automatic.22 ILARCO.22 Winchester Rimfire.22 Winchester Magnum Rimfire.25 Stevens.25 Stevens Short.32 rimfire.38 rimfire.44 Henry.46 rimfire.56-46 Spencer.56-50 Spencer.56-52 Spencer.56-56 Spencer; 2.34mm SwissMiniGun; 4.5×26mm MKR; 5 mm Remington Rimfire Magnum; 10.4×38mm ...
With normal bullet weights between 300 and 400 grains (19 and 26 g), overall cartridge length shorter than that of an AR-15 magazine well, and holding to pressures of 33,000 psi limited by the AR bolt strength system, [2] the .50 Beowulf is best described as a low-velocity, heavy caliber, making its ballistics roughly equivalent to those of ...
The Mk 211 is a very popular .50 caliber sniper round used in the Barrett M82 rifle and other .50 BMG rifles. [5] It is also often used in heavy machine guns such as the M2 Browning, but not the M85. Due to its popularity, several U.S. arms manufacturers produce the round under license from NAMMO Raufoss AS. [6]
Derived from the .50-60-400 Joslyn, the cartridge was developed after the unsatisfactory results of the .58 rimfire cartridge for the Springfield Model 1865 rifle. The .50-70 Government cartridge used the Benét internal center-fire primer design and became the official cartridge of the U.S. military in 1866 until being replaced by the .45-70 Government in 1873.
Terminal ballistics is a sub-field of ballistics concerned with ... typically on ranges up to 50 meters, or 55 yards, with low-powered ammunition like .22 long rifle, ...