Search results
Results From The WOW.Com Content Network
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.
For example, if the static compression ratio is 10:1, and the dynamic compression ratio is 7.5:1, a useful value for cylinder pressure would be 7.5 1.3 × atmospheric pressure, or 13.7 bar (relative to atmospheric pressure). The two corrections for dynamic compression ratio affect cylinder pressure in opposite directions, but not in equal strength.
Homogeneous charge compression ignition (HCCI) is a form of internal combustion in which well-mixed fuel and oxidizer (typically air) are compressed to the point of auto-ignition. As in other forms of combustion , this exothermic reaction produces heat that can be transformed into work in a heat engine .
Compression: This stroke begins at B.D.C, or just at the end of the suction stroke, and ends at T.D.C. In this stroke the piston compresses the air-fuel mixture in preparation for ignition during the power stroke (below). Both the intake and exhaust valves are closed during this stage. Combustion: Also known as power or ignition. This is the ...
Compression ratio: 9.5:1; Ignition timing (with vacuum advancer off): 10 degrees BTDC; Ignition timing (as per Haynes Databook): 5 degrees BTDC at 800 rpm; Gearbox. 4-speed and 5-speed manual gearbox: C40, C150, C152 (turbo model) Automatic transmission: A132l 3-speed, A242l 4-speed; Applications. AE92, AE111 Toyota Corolla (South Africa)
Because pressure and temperature are strongly linked, knock can also be attenuated by controlling peak combustion chamber temperatures by compression ratio reduction, exhaust gas recirculation, appropriate calibration of the engine's ignition timing schedule, and careful design of the engine's combustion chambers and cooling system as well as ...
A popular modification to the early 22R is to use a 20R head. Contrary to popular lore, the 20R head does not have smaller combustion chambers. The misunderstanding originated when the 22R came out and an advantage was its higher compression ratio, so swapping a 20R block with a 22R, there was a compression increase.
The effect is to produce an engine with a variable compression ratio. As inlet manifold pressure goes up (because of the action of the turbocharger) the effective compression ratio in the cylinder goes down (because of the increased lift of the CCV) and vice versa. This "will insure proper starting and ignition of the fuel at light loads". [1]