Search results
Results From The WOW.Com Content Network
The system has very high efficiency but, like other evaporative cooling systems, is constrained by the ambient humidity levels, which has limited its adoption for residential use. It may be used as supplementary cooling during times of extreme heat without placing significant additional burden on electrical infrastructure.
There is evidence that evaporative cooling may have been used in North Africa as early as the Old Kingdom of Egypt, circa 2500 BC. Frescoes show slaves fanning water jars, which would increase air flow around porous jars to aid evaporation and cooling the contents. [3] These jars exist even today. They are called zeer, hence the name of the pot ...
Solar energy, burning a fossil fuel, waste heat from factories, and district heating systems are examples of heat sources that can be used. An absorption refrigerator uses two coolants: the first coolant performs evaporative cooling and then is absorbed into the second coolant; heat is needed to reset the two coolants to their initial states.
Since the cooling towers are based on the principles of evaporative cooling, the maximum cooling tower efficiency depends on the wet bulb temperature of the air. The wet-bulb temperature is a type of temperature measurement that reflects the physical properties of a system with a mixture of a gas and a vapor, usually air and water vapor
Radiant cooling systems potentially offer reductions in cooling energy consumption. [10] The latent loads (humidity) from occupants, infiltration and processes generally need to be managed by an independent system. Radiant cooling may also be integrated with other energy-efficient strategies such as night time flushing, indirect evaporative ...
The average cooling potential of tropical climates varies between 10 and 40 W m 2, significantly lower than hot and dry climates. [5] For example, the cooling potential of most of southeast Asia and the Indian subcontinent is significantly diminished in the summer due to a dramatic increase in humidity, dropping as low as 10–30 W/m 2.
Demonstration of evaporative cooling. When the sensor is dipped in ethanol and then taken out to evaporate, the instrument shows progressively lower temperature as the ethanol evaporates. Rain evaporating after falling on hot pavement. Evaporation is a type of vaporization that occurs on the surface of a liquid as it changes into the gas phase. [1]
The evaporative cooling within a windtower causes the air in the tower to sink, driving circulation. This is called passive downdraught evaporative cooling (PDEC). It may also be generated using spray nozzles (which have a tendency to get blocked if the water is hard) or cold-water cooling coils (like hydronic underfloor heating in reverse).