When.com Web Search

  1. Ads

    related to: rca cables for subwoofer

Search results

  1. Results From The WOW.Com Content Network
  2. RCA connector - Wikipedia

    en.wikipedia.org/wiki/RCA_connector

    The RCA connector [3] is a type of electrical connector commonly used to carry audio and video signals. The name RCA derives from the company Radio Corporation of America, which introduced the design in the 1930s. [4] The connector’s male plug and female jack are called RCA plug and RCA jack. It is also called RCA phono connector [5] or phono ...

  3. Audio and video interfaces and connectors - Wikipedia

    en.wikipedia.org/wiki/Audio_and_video_interfaces...

    RCA Plugs for composite video (yellow) and stereo audio (white and red) RCA connectors , also known as phono connectors or phono plugs , are used for analog or digital audio or analog video. These were first used inside pre–World War II radio-phonographs to connect the turntable pickup to the radio chassis.

  4. Subwoofer - Wikipedia

    en.wikipedia.org/wiki/Subwoofer

    From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...

  5. Line level - Wikipedia

    en.wikipedia.org/wiki/Line_level

    For similar reasons, "wye"-cables (or "Y-splitters") should not be used to combine two line out signals into a single line in. Each line output would be driving the other line output as well as the intended input, again resulting in a much heavier load than designed for. This will result in signal loss and possibly even damage.

  6. S/PDIF - Wikipedia

    en.wikipedia.org/wiki/S/PDIF

    The RCA connectors are typically colour-coded orange to differentiate from other RCA connector uses such as composite video. S/PDIF uses 75 Ω coaxial cable while AES3 uses 110 Ω balanced twisted pair. Signals transmitted over consumer-grade TOSLINK connections are identical in content to those transmitted over coaxial connectors.

  7. Phone connector (audio) - Wikipedia

    en.wikipedia.org/wiki/Phone_connector_(audio)

    The USB Type-C Cable and Connector Specification specifies a mapping from a USB-C jack to a 4-pole TRRS jack, for the use of headsets, and supports both CTIA and OMTP (YD/T 1885–2009) modes. [79] Some devices transparently handle many jack standards, [80] [81] and there are hardware implementations of this available as components. [82]