Ad
related to: 300 ohm folded dipole tv antenna calculator
Search results
Results From The WOW.Com Content Network
The G5RV antenna is a dipole antenna fed indirectly, through a carefully chosen length of 300 Ω or 450 Ω twin lead, which acts as an impedance matching network to connect (through a balun) to a standard 50 Ω coaxial transmission line. The sloper antenna is a slanted vertical dipole antenna attached to the top of a single tower. The element ...
The balun is a 16:1 ratio, thereby transforming the 50 Ω (ohm) coax to an 800 Ω feed at the antenna. The resistor load is also 800 Ω , non-inductive. This allows the antenna impedance to swing from 400–1,600 Ω over the frequency range intended and thus keep the SWR at the transmitter 2:1 or lower.
Twin-lead also can serve as a convenient material with which to build a simple folded dipole antenna. Such antennas may be fed either by using a 300 Ω twin-lead feeder or by using a 300-to-75 Ω balun and using coaxial feedline and will usually handle moderate power loads without overheating.
The 1 / 2 λ dipole and the 1 / 2 λ folded dipole are commonly taken as having nominal impedances of 75 Ω and 300 Ω, respectively. [13] An installed antenna's feed-point impedance varies above and below the quoted value, depending on its installation height above the ground and the electrical properties of the surrounding earth.
Yagi antenna for UHF TV reception with 22 parasitic elements; 4 reflectors attached to the vertical bracket at left, and 18 directors attached to the horizontal beam at right. The driven element is attached to the black box next to the reflectors. The antenna is most sensitive to radio waves coming from the right, parallel to the antenna's axis.
Consider a Yagi–Uda consisting of a reflector, driven element, and a single director as shown here. The driven element is typically a 1 ⁄ 2 λ dipole or folded dipole and is the only member of the structure that is directly excited (electrically connected to the feedline). All the other elements are considered parasitic. That is, they ...
Inverted-'V' antenna When the two arms of a dipole are individually straight, but bent towards each other in a 'V' shape, at an angle noticeably less than 180°, the dipole is called a 'V' antenna, and when the dipole arms' end closer to the ground than their center branch-point, the antenna is called an inverted-'V' . The inverted-'V' is ...
Earlier antennas used a flat cable called 300 ohm twin-lead. The standard today is 75 ohm coaxial cable , which is less susceptible to interference which plugs into an F connector or Belling-Lee connector (depending on region) on the back of the TV. [ 6 ]