Search results
Results From The WOW.Com Content Network
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks.The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination. The sum of the mean times in each hop is a measure of the total time spent to establish the connection. The command aborts if all (usually three) sent packets are lost more than twice.
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header.It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header.
The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network. A remote network is a network that can only be reached by sending the packet to another router. Routing table entries to remote networks may be either dynamic or static.
The inside of a Cisco 1900-series switch. Catalyst is the brand for a variety of network switches, wireless controllers, and wireless access points sold by Cisco Systems.While commonly associated with Ethernet switches, a number of different types of network interfaces have been available throughout the history of the brand.
A physical Ethernet interface, for example, can have logical interfaces in several virtual LANs defined by IEEE 802.1Q VLAN headers. When an interface has an address configured in a subnet , such as 192.0.2.1 in the 192.0.2.0/24 (i.e., subnet mask 255.255.255.0) subnet, and that interface is considered "up" by the router, the router thus has a ...
The label edge routers at the edges of an MPLS cloud map between the end-to-end identifier, such as an IP address, and a link-local label. At each MPLS hop, there is a forwarding table that tells the label-switched router which outgoing interface is to receive the MPLS packet, and what label to use when sending the packet out that interface.
An incoming long packet is broken up into a sequence of shorter packets and enough information is added to reassemble that long frame at the far end. FRF.12 is a specification from the Frame Relay Forum which specifies how to perform fragmentation on frame relay traffic primarily for voice traffic.