When.com Web Search

  1. Ad

    related to: engine tapping when accelerating start method diagram labeled pdf

Search results

  1. Results From The WOW.Com Content Network
  2. Tappet - Wikipedia

    en.wikipedia.org/wiki/Tappet

    On some OHV engines in the 1960s, such as the Ford Taunus V4 engine and Opel CIH engine, the tappet adjustment was done by setting the height of the rocker pivot point (rather than the typical method of a rocker-end adjustment screw). On the 1965-1970 versions of the Opel CIH engine with solid tappets, the tappet adjustment was conducted with ...

  3. Engine knocking - Wikipedia

    en.wikipedia.org/wiki/Engine_knocking

    In spark-ignition internal combustion engines, knocking (also knock, detonation, spark knock, pinging or pinking) occurs when combustion of some of the air/fuel mixture in the cylinder does not result from propagation of the flame front ignited by the spark plug, but when one or more pockets of air/fuel mixture explode outside the envelope of the normal combustion front.

  4. Starter (engine) - Wikipedia

    en.wikipedia.org/wiki/Starter_(engine)

    An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.

  5. Component parts of internal combustion engines - Wikipedia

    en.wikipedia.org/wiki/Component_parts_of...

    Compressed air can be supplied from another engine, a unit on the ground or by the aircraft's APU. Small internal combustion engines are often started by pull cords. Motorcycles of all sizes were traditionally kick-started, though all but the smallest are now electric-start.

  6. Throttle position sensor - Wikipedia

    en.wikipedia.org/wiki/Throttle_position_sensor

    Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. [1] Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.

  7. Hydraulic tappet - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_tappet

    It is a myth that in certain circumstances, a lifter can "pump up" and create negative valve clearance. The engine oil pump cannot generate enough pressure to cause "pump-up". The problem is due to weak valve springs which permit float at high engine speeds. The followers attempt to take up what they see as extra clearance.

  8. Today's Wordle Hint, Answer for #1275 on Sunday, December 15 ...

    www.aol.com/todays-wordle-hint-answer-1275...

    If you’re stuck on today’s Wordle answer, we’re here to help—but beware of spoilers for Wordle 1275 ahead. Let's start with a few hints.

  9. Pre-ignition - Wikipedia

    en.wikipedia.org/wiki/Pre-ignition

    The reduced engine speeds allow more time for autoignition chemistry to complete thus promoting the possibility of pre-ignition and so called "mega-knock". Under these circumstances, there is still significant debate as to the sources of the pre-ignition event. [3] Pre-ignition and engine knock both sharply increase combustion chamber temperatures.