Search results
Results From The WOW.Com Content Network
The drivers for a software-implemented modem create a virtual serial port for communication with the host operating system, since the modem is implemented entirely in the device driver and therefore there is no point where the serial data would be sent to the physical card.
Direct numerical control (DNC), also known as distributed numerical control (also DNC), is a common manufacturing term for networking CNC machine tools.On some CNC machine controllers, the available memory is too small to contain the machining program (for example machining complex surfaces), so in this case the program is stored in a separate computer and sent directly to the machine, one ...
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
Software flow control is a method of flow control used in computer data links, especially RS-232 serial. It uses special codes, transmitted in-band, over the primary communications channel. These codes are generally called XOFF and XON (from "transmit off" and "transmit on", respectively). Thus, "software flow control" is sometimes called "XON ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
A male D-subminiature connector used for an RS-232 serial port on an IBM PC compatible computer along with the serial port symbol. A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1]
In 1986, GE Fanuc Automation Corporation was jointly established in the US by FANUC and General Electric (GE). Under the joint venture company, three operating companies, GE Fanuc Automation North America, Inc., in the U.S., GE Fanuc Automation Europe S.A. in Luxembourg, and Fanuc GE Automation Asia Ltd. in Japan were established (the Asian company was established in 1987).