Ads
related to: 4x4 deck post anchor base on cement floor plan calculator images clip art
Search results
Results From The WOW.Com Content Network
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
The anchor selection, together with additional reinforcement, and rigging arrangements is influenced by: - The dead weight of the element - The number of anchors in the element and the configuration of the anchor - Capacity of the anchor at the specific concrete compressive strengths at time of lift - The dynamic loads applied during lifting ...
Bonded anchors are also referred as adhesive anchors [9] or chemical anchors. The anchoring material is an adhesive (also called mortar) [3] usually consisting of epoxy, polyester, or vinylester resins. [1] In bonded anchors, the force-transfer mechanism is based on bond stresses provided by binding organic materials.
Helical anchors consist of an extendable steel shaft with helical bearing plates. Piles or piers refer to strong base elements that withstand or transfer vertical/horizontal loads. Anchors are piles utilised only in tension applications like restraining wall tiebacks or vertical ground anchors made to resist overturning forces.
A composite steel deck combines the tensile strength of steel with the compressive strength of concrete to improve design efficiency and reduce the material necessary to cover a given area. Additionally, composite steel decks supported by composite steel joists can span greater distances between supporting elements and have reduced live load ...
An earth anchor is a device designed to support structures, most commonly used in geotechnical and construction applications. Also known as a ground anchor , percussion driven earth anchor or mechanical anchor , it may be impact driven into the ground or run in spirally, depending on its design and intended force-resistance characteristics.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
Alteration of hardened cement paste composition, with monosulfate aluminates phase converting to ettringite and, in later stages, gypsum formation. The necessary additional calcium is provided by the calcium hydroxide and calcium silicate hydrate in the cement paste; The effect of these changes is an overall loss of concrete strength.