Search results
Results From The WOW.Com Content Network
The term quad buffering is the use of double buffering for each of the left and right eye images in stereoscopic implementations, thus four buffers total (if triple buffering was used then there would be six buffers). The command to swap or copy the buffer typically applies to both pairs at once, so at no time does one eye see an older image ...
Direct3D does not implement a most-recent buffer swapping strategy, and Microsoft's documentation calls a Direct3D swap chain of three buffers "triple buffering". Triple Buffering as described above is superior for interactive purposes such as gaming, but Direct3D swap chains of more than three buffers can be better for tasks such as presenting ...
In telecommunications networks, independent clocks are free-running precision clocks located at the nodes which are used for synchronization.. Variable storage buffers, installed to accommodate variations in transmission delay between nodes, are made large enough to accommodate small time departures among the nodal clocks that control transmission.
In digital electronics, a tri-state or three-state buffer is a type of digital buffer that has three stable states: a high output state, a low output state, and a high-impedance state. In the high-impedance state, the output of the buffer is disconnected from the output bus, allowing other devices to drive the bus without interference from the ...
The number of data and formatting bits, the order of data bits, the presence or absence of a parity bit, the form of parity (even or odd) and the transmission speed must be pre-agreed by the communicating parties. The "stop bit" is actually a "stop period"; the stop period of the transmitter may be arbitrarily long.
While X was filled with fans eager to watch the start of Jake Paul vs. Mike Tyson on Netflix, many were complaining about buffering and image issues during earlier fights, causing disappointment ...
A switch using store-and-forward transmission will receive (save) the entire packet to the buffer and check it for CRC errors or other problems before sending the first bit of the packet into the outbound link. Thus, store-and-forward packet switches introduce a store-and-forward delay at the input to each link along the packet's route.
In computer science, a data buffer (or just buffer) is a region of memory used to store data temporarily while it is being moved from one place to another. Typically, the data is stored in a buffer as it is retrieved from an input device (such as a microphone) or just before it is sent to an output device (such as speakers); however, a buffer may be used when data is moved between processes ...