Search results
Results From The WOW.Com Content Network
An overhead valve engine, abbreviated (OHV) and sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with flathead (or "sidevalve") engines , where the valves were located below the combustion chamber in the engine block .
Part of the Hercules DFX series, the DFXE is a naturally aspirated, direct injection,overhead valve, inline six-cylinder engine. [1] [2] The engine had a displacement of 855 cu in (14.011 L), with a bore of 5 + 5 ⁄ 8 in (143 mm), a stroke of 6 in (150 mm) and a compression ratio of 14.8:1.
Series 452 engine in the Deutsches Technikmuseum Berlin. The Cadillac V16 engine is a term that applies to two different Cadillac-designed V-16 automobile engines, an overhead valve 45-degree 452 cu in (7.4 L) model produced between 1930 and 1937, and a 135-degree side valve 431 cu in (7.1 L) between 1938 and 1940.
Volvo B18 engine. The B18 is a 1.8 L overhead valve (OHV) engine with two valves per cylinder. It has five main bearings, two more than the B16. With a bore of 84.14 mm (3.31 in) and stroke of 80 mm (3.15 in), the B18 displaces 1,778 cc (108.5 cu in). The cylinders are on 105 / 108 mm (4.13 / 4.25 in) split bore centers, where the spacing ...
A more modern technique for four-stroke engines, variable valve timing, attempts to address changes in volumetric efficiency with changes in speed of the engine: at higher speeds the engine needs the valves open for a greater percentage of the cycle time to move the charge in and out of the engine.
The Chevrolet Inline-4 engine was one of Chevrolet's first automobile engines, designed by Arthur Mason and introduced in 1913. Chevrolet founder Billy Durant, who previously had owned Buick which had pioneered the overhead valve engine, used the same basic engine design for Chevrolet: exposed pushrods and rocker arms which actuated valves in the detachable crossflow cylinder head.
Speed has dropped out of the equation, and the only variables are the torque and displacement volume. Since the range of maximum brake mean effective pressures for good engine designs is well established, we now have a displacement-independent measure of the torque-producing capacity of an engine design – a specific torque of sorts.
Cutaway of a dual overhead camshaft engine 1969 AMC V8 overhead valve engine. The rocker cover has been removed, so the pushrods, rocker arms, valve springs, and valves are visible. A valvetrain is a mechanical system that controls the operation of the intake and exhaust valves in an internal combustion engine. [1]