When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   The USB 3.0 Micro-B plug effectively consists of a standard USB 2.0 Micro-B cable plug, with an additional 5 pins plug "stacked" to the side of it. In this way, cables with smaller 5 pin USB 2.0 Micro-B plugs can be plugged into devices with 10 contact USB 3.0 Micro-B receptacles and achieve backward compatibility.

3. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   The legacy USB Type-A plug. This is one of many legacy types of USB connector. The design is intended to make it difficult to insert a USB plug into its receptacle incorrectly. The USB specification requires that the cable plug and receptacle be marked so the user can recognize the proper orientation. [30] The USB-C plug however is reversible.

4. USB 3.0 - Wikipedia

   en.wikipedia.org/wiki/USB_3.0

   USB 3.0 also introduced a new Micro-B cable plug, which consists of a standard USB 1.x/2.0 Micro-B cable plug, with an additional 5-pin plug "stacked" beside it. That way, the USB 3.0 Micro-B host receptacle preserves its backward compatibility with the USB 1.x/2.0 Micro-B cable plug, allowing devices with USB 3.0 Micro-B ports to run at USB 2. ...

5. USB On-The-Go - Wikipedia

   en.wikipedia.org/wiki/USB_On-The-Go

   An OTG cable has a micro-A plug on one end, and a micro-B plug on the other end (it cannot have two plugs of the same type). OTG adds a fifth pin to the standard USB connector, called the ID-pin; the micro-A plug has the ID pin grounded, while the ID in the micro-B plug is floating.

6. USB-C - Wikipedia

   en.wikipedia.org/wiki/USB-C

   Some non-compliant cables with a USB-C connector on one end and a legacy USB-A plug or Micro-B receptacle (receptacles also usually being invalid on cables, but see known exceptions in the sections on Hosts and peripheral devices and Audio adapter accessory mode above) on the other end incorrectly terminate the Configuration Channel (CC) with a ...

7. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.