Search results
Results From The WOW.Com Content Network
The GTP convertible was not available with the manual transmission and reduced its power to 227 hp, due to a more restrictive exhaust system. The GTP also featured standard electronic stability control. The 2007 G6 saw more engine changes, and standard side torso and side curtain airbags (actually introduced late in the 2006 model year) were new.
Its first use in a North American application was the Pontiac G6 for the 2006 model year. It is also used in some Saab 9-3 and 9-5 models. It is a three-axis design, with first, second, fifth, and sixth gears on an output shaft behind and below the input shaft, and third and fourth gears are on an output shaft in front of and above the input shaft.
The first application of the technology was in the 2007 Ford Edge and Lincoln MKX crossover SUVs, as well as the Saturn Aura sedan and the Saturn Outlook crossover. It was also used for the Pontiac G6 GTP models and the GMC Acadia models for 2007. Prior to 2009, this transmission had issues caused by a very weak 3,5,R wave plate, which made ...
On September 21, 2012. General Motors recalled 473,841 vehicles involving the Chevrolet Malibu, Pontiac G6 and Saturn Aura from model years 2007 through 2010 equipped with four-speed automatic transmissions. The problem is a condition that could make cars roll when in park.
The National Highway Traffic Safety Administration is investigating reports of alleged engine failures in GM's 6.2-liter L87 V-8, an engine used in a wide variety of trucks and SUVs.
For 1991 GM introduced the 4T60-E which was a 4T60 with electronic controls, first seen on the new Buick Park Avenue.One benefit was that the cruise control was integrated into the gearbox' electronic control module, improving the ability to maintain a set speed while avoiding needless shifting, thus lowering fuel consumption and noise levels. [1]
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
The "MN4" 4T40E is able to handle vehicles up to 4000 lb (1814 kg) GVWR. The final drive ratio can vary depending on the car's curb weight and engine power output. 3.91, 3.63, 3.29, 3.05, 3.69, and 3.42 are all of the available ratios used in the 4T40 (and 4T45) transmission; Made possible by using combinations selected from 3 different sprocket combinations (32/38, 35/35, 33/37) and 2 ...