When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. RTV silicone - Wikipedia

   en.wikipedia.org/wiki/RTV_silicone

   Silicones also exhibit good chemical resistance and high-temperature resistance (205 °C, 400 °F and higher). For this reason, silicone molds are suitable for casting low-melt metals and alloys (e.g. zinc, tin, pewter, and Wood's metal). RTV silicone rubbers are, however, generally expensive – especially platinum-cure.

3. Melt and pour - Wikipedia

   en.wikipedia.org/wiki/Melt_and_pour

   The liquified concoction can be poured into individual molds, tray molds, or blocks. Molds are made of metal or, more commonly, from plastic or reinforced silicone rubber, allowing artisans to make their own molds using a two-part mold kit. Upon cooling, the soap can be removed from the molds as individual soaps, or as blocks for slicing into bars.

4. Injection molding of liquid silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Injection_molding_of...

   Injection molding of liquid silicone rubber (LSR) is a process to produce pliable, durable parts in high volume. Liquid silicone rubber is a high purity platinum cured silicone with low compression set, good stability and ability to resist extreme temperatures of heat and cold ideally suitable for production of parts, where high quality is ...

5. Silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Silicone_rubber

   In its uncured state, silicone rubber is a highly adhesive gel or liquid. To convert it to a solid, it must be cured, vulcanized, or catalyzed.This is normally carried out in a two-stage process at the point of manufacture into the desired shape, and then in a prolonged post-cure process.

6. Silicone - Wikipedia

   en.wikipedia.org/wiki/Silicone

   Two-part silicone systems are used as rubber molds to cast resins, foams, rubber, and low-temperature alloys. A silicone mold generally requires little or no mold-release or surface preparation, as most materials do not adhere to silicone. For experimental uses, ordinary one-part silicone can be used to make molds or to mold into shapes.

7. How to Make a Jell-O Mold That Comes Out Perfect

   www.aol.com/jell-o-mold-comes-perfect-150003594.html

   Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...