Search results
Results From The WOW.Com Content Network
Elastomeric bearing pads are the most economical solution used in construction of large span bridges and buildings. [1] [2] Elastomeric bearings are often used in applications other than bridges, for example, supporting buildings that are built on soil that may shift slightly and cause a concrete load to crack in the absence of a elastomeric ...
BS 5400-9.1:1983 Steel, concrete and composite bridges. Bridge bearings. Code of practice for design of bridge bearings. (This part of standard is partially replaced by BS EN 1337-2 , BS EN 1337-3 , BS EN 1337-5 and BS EN 1337-7 , and replaced by BS EN 1337-4 and BS EN 1337-6 but remains current) BS 5400-9.2:1983 Steel, concrete and composite ...
There are several different types of bridge bearings which are used depending on a number of different factors including the bridge span, loading conditions, and performance specifications. [2] The oldest form of bridge bearing is simply two plates resting on top of each other. A common form of modern bridge bearing is the elastomeric bridge ...
The total movement of the bridge deck is divided among a number of individual gaps which are created by horizontal surface beams. The individual gaps are sealed by watertight elastomeric profiles, and surface beam movements are regulated by an elastic control system. The drainage of the joint is via the drainage system of the bridge deck.
The longest steel reinforced bridge, in 2024, is the 600 metres (2,000 ft) Tian'e Longtan Bridge, Guangxi Zhuang, China. [8] The US's longest unreinforced concrete span, is the 200 feet (61 m) arch of the, 1910, Rocky River Bridge in Cleveland, Ohio. [9] Early extant examples include:
In engineering, span is the distance between two adjacent structural supports (e.g., two piers) of a structural member (e.g., a beam).Span is measured in the horizontal direction either between the faces of the supports (clear span) or between the centers of the bearing surfaces (effective span): [1]
Attempts have been made to increase the safety of bridges with pin and hanger assemblies by adding some form of redundancy to the assembly. Retrofits that add redundancy to pin and hanger assemblies include adding a "catcher's mitt"—a short steel beam attached to the bottom of the cantilevered girder that extends out beneath the suspended girder to "catch" the suspended girder should ...
The Martel bridge was adopted by the British Army in 1925 as the Large Box Girder Bridge. [2] A scaled down version of this design, the Small Box Girder Bridge, was also formally adopted by the Army in 1932. This latter design was copied by many countries, including Germany, who called their version the Kastenträger-Gerät (K-Gerät for short ...