Search results
Results From The WOW.Com Content Network
A clamper will bind the upper or lower extreme of a waveform to a fixed DC voltage level. These circuits are also known as DC voltage restorers. Clampers can be constructed in both positive and negative polarities. When unbiased, clamping circuits will fix the voltage lower limit (or upper limit, in the case of negative clampers) to 0 volts.
A clamper circuit is not a clipper, but the simple diode version has a similar topology to a clipper with the exception that the resistor is replaced with a capacitor. The clamper circuit fixes either the positive or negative peaks at a fixed voltage (determined by the biasing voltage) rather than clipping them off.
A transient-voltage-suppression diode can respond to over-voltages faster than other common over-voltage protection components such as varistors or gas discharge tubes. The actual clamping occurs in roughly one picosecond, but in a practical circuit the inductance of the wires leading to the device imposes a higher limit. This makes transient ...
Baker called the technique "back clamping", but the circuit is now called a Baker clamp. Many sources credit Baker's report for the two-diode clamp circuit. [3] [4] [5] Also in 1956, Baker described the circuit in a patent application; the 1961 issued patent US 3,010,031 [6] claims the use of the clamp in symmetrical flip-flop circuits.
It is known as a current-limiting diode (CLD) or current-regulating diode (CRD). Internal structure. It consists of an n-channel JFET with the gate shorted to the source, which functions like a two-terminal current limiter (analogous to a voltage-limiting Zener diode). It allows a current through it to rise to a certain value, but not higher.
If the voltage increases beyond the design limit, the diode goes into avalanche breakdown, causing the harmful voltage to be conducted to ground. When used in this fashion, they are often referred to as clamping diodes or transient-voltage suppressors because they fix or "clamp" the maximum voltage to a predetermined level.
The circuits are now known as Baker clamps. One of those clamp circuits used a single germanium diode to clamp a silicon transistor in a circuit configuration that is the same as the Schottky transistor. [22]: 11, 30 The circuit relied on the germanium diode having a lower forward voltage drop than a silicon diode would have.
This simple diode clamp will clamp the negative peaks of the incoming waveform to the common rail voltage. A diode clamp circuit can take a periodic alternating current signal that oscillates between positive and negative values, and vertically displace it such that either the positive or the negative peaks occur at a prescribed level. The ...