Ads
related to: how to calculate circulator size of water treatment methods
Search results
Results From The WOW.Com Content Network
Tubular forced circulation evaporators employs an axial circulation pump which navigates the flow of liquid in a circular motion through the system's heat exchanger in which it is superheated. Thereafter, when the liquid reaches the separator the liquid pressure decreases dramatically forcing a portion of the liquid to be rapidly boiled off.
The RBC process allows the wastewater to come in contact with a biological film in order to remove pollutants in the wastewater before discharge of the treated wastewater to the environment, usually a body of water (river, lake or ocean). A rotating biological contactor is a type of secondary (biological) treatment process.
A circulator pump for home use. A circulator pump or circulating pump is a specific type of pump used to circulate gases, liquids, or slurries in a closed circuit with small elevation changes. They are commonly found circulating water in a hydronic heating or cooling system.
Air is generally pumped at least as deep under the water as the water is to be lifted. (If the water table is 50 ft below, the air should be pumped 100 feet deep). It is also sometimes used in part of the process on a wastewater treatment plant if a small head is required (typically around 1 foot head).
A forced circulation boiler is a boiler where a pump is used to circulate water inside the boiler. This differs from a natural circulation boiler which relies on current density to circulate water inside the boiler. In some forced circulation boilers, the water is circulated at twenty times the rate of evaporation. [1]
Thermal immersion circulator. A thermal immersion circulator is an electrically powered device that circulates and heats a warm fluid kept at an accurate and stable temperature. [1] It is used in process, environmental, microbiological, hazardous waste, and other laboratories.
TSS of a water or wastewater sample is determined by pouring a carefully measured volume of water (typically one litre; but less if the particulate density is high, or as much as two or three litres for very clean water) through a pre-weighed filter of a specified pore size, then weighing the filter again after the drying process that removes all water on the filter.
A biofilter and CO 2 degasser on an outdoor recirculating aquaculture system used to grow largemouth bass Water treatment processes needed in a recirculating aquaculture system. A series of treatment processes is utilized to maintain water quality in intensive fish farming operations. These steps are often done in order or sometimes in tandem.