Search results
Results From The WOW.Com Content Network
The glowing splint test is a test for an oxidising gas, such as oxygen. [4] In this test, a splint is lit, allowed to burn for a few seconds, then blown out by mouth or by shaking. Whilst the ember at the tip is still glowing hot, the splint is introduced to the gas sample that has been trapped in a vessel.
Nitrous oxide (dinitrogen oxide or dinitrogen monoxide), commonly known as laughing gas, nitrous, or factitious air, among others, [4] is a chemical compound, an oxide of nitrogen with the formula N 2 O. At room temperature, it is a colourless non-flammable gas, and has a slightly sweet scent and taste. [4]
This list is sorted by boiling point of gases in ascending order, but can be sorted on different values. "sub" and "triple" refer to the sublimation point and the triple point, which are given in the case of a substance that sublimes at 1 atm; "dec" refers to decomposition. "~" means approximately.
an identification of the product; a signal word – either Danger or Warning – where necessary; hazard statements, indicating the nature and degree of the risks posed by the product; precautionary statements, indicating how the product should be handled to minimize risks to the user (as well as to other people and the general environment)
"NFPA 704: Standard System for the Identification of the Hazards of Materials for Emergency Response" is a standard maintained by the U.S.-based National Fire Protection Association. First "tentatively adopted as a guide" in 1960, [ 1 ] and revised several times since then, it defines the " Safety Square " or " Fire Diamond " which is used to ...
Normal high pressure gas cylinders will hold gas at pressures from 200 to 400 bars (3,000 to 6,000 psi). An ideal gas pressurised to 200 bar in a cylinder would contain 200 times as much as the volume of the cylinder at atmospheric pressure, but real gases will contain less than that by a few percent. At higher pressures, the shortfall is greater.
A gas cylinder is used to store gas or liquefied gas at pressures above normal atmospheric pressure. [2] In South Africa, a gas storage cylinder implies a refillable transportable container with a water capacity volume of up to 150 litres. Refillable transportable cylindrical containers from 150 to 3,000 litres water capacity are referred to as ...
After inoculation and incubation, any gas that is produced will form a visible gas bubble inside the small tube. [1] Litmus solution can also be added to the culture media to give a visual representation of pH changes that occur during the production of gas. [1] [2] The method was first reported in 1898 by British microbiologist Herbert Durham. [1]