Ad
related to: how to diagnose faulty ecm valve on honda- In-Vehicle Apps
Entertainment, Music, & News.
Make The Most Of Your Drive.
- The OnStar Difference
Better Safety. Better Entertainment
Better Drives. Better Control
- OnStar Safety Services
Helps Give You And Your Family
Safety Services Wherever You Are.
- Connected Vehicles
A More Efficient & Enjoyable Drive
Seamlessly Bridge Life & Travels
- OnStar Services
Review Plans
Learn More About OnStar Offerings.
- Rapid Response Available
We're Here With First Responders
We Help Build Safer Communities
- In-Vehicle Apps
Search results
Results From The WOW.Com Content Network
In theory, the closing of all rear bank valves produces an ‘air spring’ effect. However, the reciprocating effect of the piston with closed valves reportedly produces a vacuum condition where oil can get pulled past the piston rings to flood the cylinder. When VCM disengages, the engine then misfires if needing to clear the cylinder of oil.
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
This interface was made in different varieties and changed with power train control modules (aka PCM, ECM, ECU). Different versions had slight differences in pin-outs and baud rates. Earlier versions used a 160 baud rate, while later versions went up to 8192 baud and used bi-directional communications to the PCM. [15] [16]
An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine. Systems commonly controlled by an ECU include the fuel injection and ignition systems.
A servo motor controlled by the ECU opens and shuts the valve. [1] The valve goes from being almost fully closed at idle speed, through to fully open at higher engine speeds. This ensures low to mid-range performance, more linear power output and reduced exhaust noise levels while the valve is in its reduced opening position.
An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
A Honda K24A Engine with i-VTEC. VTEC (described as Variable Valve Timing & Lift Electronic Control, but stands for Valve Timing Electronically Controlled) is a system developed by Honda to improve the volumetric efficiency of a four-stroke internal combustion engine, resulting in higher performance at high RPM, and lower fuel consumption at low RPM.
Leak-down testing is a static test. Leak-down tests cylinder leakage paths. Leak-down primarily tests pistons and rings, seated valve sealing, and the head gasket. Leak-down will not show valve timing and movement problems, or piston movement related sealing problems. Any test should include both compression and leak-down.