Ads
related to: air intake wiki
Search results
Results From The WOW.Com Content Network
Some strategies used in designing aftermarket cold air intakes are: Reworking parts of the intake that create turbulence to reduce air resistance. [2] Providing a more direct route to the air intake by eliminating muffling devices. Shortening the length of the intake. Placing the intake duct to use the ram-air effect to give positive pressure ...
Aircraft using piston engines use intake systems similar to automobiles. With the development of jet engines and the subsequent ability of aircraft to travel at supersonic speeds, it was necessary to design inlets to provide the flow required by the engine over a wide operating envelope and to provide air with a high-pressure recovery and low distortion.
A heated air inlet or warm air intake is a system commonly used on the original air cleaner assemblies of carburetted engines to increase the temperature of the air going into the engine for the purpose of improving the consistency of the air/fuel mixture to reduce engine emissions and fuel usage. [1]
Ram-air intake on a Kawasaki ZX-12R. A ram-air intake is any intake design which uses the dynamic air pressure created by vehicle motion, or ram pressure, to increase the static air pressure inside of the intake manifold on an internal combustion engine, thus allowing a greater massflow through the engine and hence increasing engine power.
The air intake (inlet U.S. [6]) is an aerodynamic duct extending from an entry lip to the engine fan/compressor. For supersonic intakes with variable geometry it is called an intake system, referring to the need for shock-wave and internal duct flow management using variable position surfaces (ramps or cones) and bypass doors. [7]
The original intake is shown in the top image. The fundamental design of a gas turbine engine is such that the air flow-rate entering its compressor is regulated by the amount of fuel burned in its combustor. For supersonic flight the air entering the inlet also has to be regulated to a similar amount by the design of the entrance of the inlet ...