Ads
related to: 5.25 external optical drive caddy
Search results
Results From The WOW.Com Content Network
The format was standardized as EIA-741 and co-published as SFF-8501 for disk drives, with other SFF-85xx series standards covering related 5.25 inch devices (optical drives, etc.) [33] The Quantum Bigfoot HDD was the last to use it in the late 1990s, with "low-profile" (≈25 mm) and "ultra-low-profile" (≈20 mm) high versions.
In the consumer market, commonly used configurations of drive enclosures utilize magnetic hard drives or optical disc drives inside USB, FireWire, or Serial ATA enclosures. External 3.5-in floppy drives are also fairly common, following a trend to not integrate floppy drives into compact and laptop computers. Pre-built external drives are ...
The third series of Bigfoot drives was known as the Quantum Bigfoot TX series. This series increased the drives' spindle speed to 4,000 RPM and upgraded their interface capabilities to ATA-66. These drives carried the higher capacities of 4 GB, 6 GB, 8 GB and 12 GB. Like the CY series, access time was advertised as under 12 ms.
From left to right: full-height 5.25″ drive, two half-height 5.25″ drives, and (sideways) a 3.5″ drive. A drive bay is a standard-sized area for adding hardware to a computer. Most drive bays are fixed to the inside of a case, but some can be removed.
A magneto-optical drive is a kind of optical disc drive capable of writing and rewriting data upon a magneto-optical disc. 130 mm (5.25 in) and 90 mm (3.5 in) discs are the most common sizes. In 1983, just a year after the introduction of the compact disc , Kees Schouhamer Immink and Joseph Braat presented the first experiments with erasable ...
Optical drives for computers come in two main form factors: half-height (also known as desktop drive) and slim type (used in laptop computers and compact desktop computers). They exist as both internal and external variants. Half-height optical drives are around 4 centimetres tall, while slim type optical drives are around 1 cm tall.
The M3 threaded holes are often found on 5.25" optical disc drives, 3.5" floppy drives, and 2.5" drives. Motherboards and other circuit boards often use a #6-32 UNC standoff. #4-40 UNC thumb screws are often found on the ends of DVI , VGA , serial and parallel connectors.
Conner Peripherals HDD with 213 MB capacity. Conner's drives were notable for eschewing the "tub" type of head-disk assembly, where the disks are inside a large base casting shaped like a square bowl or vault with a flat lid; instead, they preferred the flat base plate approach, which was more resistant to shock and less likely to warp or deform when heated. [5]