Search results
Results From The WOW.Com Content Network
One taut-line hitch is tied 15–30 cm from the aircraft and adjusted for tension, then a second taut-line hitch is tied 5–20 cm further from the aircraft and finished with a half-hitch. Wind-induced lift tends to pull the knot tighter, gust-induced oscillations tend to damp-out, and once the half hitch is undone, pushing the lower working ...
Three Dornier 228 of Aerocardal at the airline's Arturo Merino Benítez International Airport base. A fixed-base operator (FBO) is an organization granted the right by an airport to operate at the airport and provide aeronautical services such as fueling, hangaring, tie-down, and parking, aircraft rental, aircraft maintenance, flight instruction, and similar services. [1]
Analytical techniques such as this led to lighter and stronger aircraft and became widely adopted. At the same time, the amount of bracing could be progressively reduced. At low speeds a thin wire causes very little drag and early flying machines were sometimes called "bird cages" due to the number of wires present.
Cleco (Cleko) fasteners on an aircraft wing. A cleco, also spelled generically cleko, is a temporary fastener developed by the Cleveland Pneumatic Tool Company. [1] Widely used in the manufacture and repair of aluminum-skinned aircraft, it is used to temporarily fasten sheets of material together, or to hold parts such as stiffeners, frames etc together, before they are permanently joined.
To assume a brace position or crash position is an instruction that can be given to prepare for a crash, such as on an aircraft; the instruction to "Brace for impact!" or "Brace! Brace!" is often given if the aircraft must make an emergency landing on land or water. There are many different ways to adopt the brace position, with many countries ...
A typical metal spar in a general aviation aircraft usually consists of a sheet aluminium spar web, with L- or T-shaped spar caps being welded or riveted to the top and bottom of the sheet to prevent buckling under applied loads. Larger aircraft using this method of spar construction may have the spar caps sealed to provide integral fuel tanks.
An engineered materials arrestor system, engineered materials arresting system (EMAS), or arrester bed [1] is a bed of engineered materials built at the end of a runway to reduce the severity of the consequences of an aircraft running off the end of a runway. Engineered materials are defined in FAA Advisory Circular No 150/5220-22B as "high ...
The rear section of the tailplane is called the elevator, and is a movable aerofoil that controls changes in pitch, the up-and-down motion of the aircraft's nose. In some aircraft the horizontal stabilizer and elevator are one unit, and to control pitch the entire unit moves as one. This is known as a stabilator or full-flying stabiliser. [1] [2]