Search results
Results From The WOW.Com Content Network
The relationship between gallons per minute (gpm) and fixture unit is not constant, but varies with the number of fixture units. For example, 1000 FU is equivalent to 220 US gallons per minute (0.014 m 3 /s) while 2000 FU represents only 330 US gallons per minute (0.021 m 3 /s), about 1.5 times the flow rate.
Examples include a showerhead with flow rate of 1.75 gpm (6.61 lpm) at high water pressure and 1.45 gpm (5.48 lpm) at low pressure, or a showerhead with three pressure compensated flow rates (by non-removable pressure compensator) with options of 0.5, 1.0 and 1.5 gpm (1.9, 3.8, 5.7 lpm).
Kitchen and bathroom faucets were limited to a flow rate of 2.2 gpm (gallons per minute) at 60 psi, and residential shower heads were limited to a flowrate of 2.5 gpm at 80 psi. [ 3 ] In response to an increasing number of water shortages and increased water utility rates there has been recent legislation by many states leading the way in water ...
Using the efficiency standards established by EPACT92 as a baseline, the EPA instituted the following flow-rate guidelines for WaterSense: toilets must be manufactured with a maximum flush volume of 1.28 gpf; showerheads must have a maximum flow-rate of 2.0 gpm at 80 psi; and bathroom faucets must be manufactured with a low-flow volume rate of ...
Showerheads ≤ 2.0 gpm (gallons per minute) @ 80 psi; Lavatory faucets ≤ 1.5 gpm @ 60 psi; Kitchen faucets ≤ 1.8 gpm @ 60 psi; Urinals ≤ 0.5 gal/flush; Waterclosets ≤ 1.28 gallon effective flush rate; The performance method uses the performance calculation worksheets in Chapter 8 (or other calculation acceptable to the enforcing agency ...
K-Factors have also previously been calculated and published using the United States customary units of pound per square inch (psi) and gallon per minute (gpm). Within the United States, US measurements are still often used instead of metric.
The standard liter per minute (SLM or SLPM) is a unit of (molar or) mass flow rate of a gas at standard conditions for temperature and pressure (STP), which is most commonly practiced in the United States, whereas European practice revolves around the normal litre per minute (NLPM). [1]
Turndown ratio refers to the width of the operational range of a device, and is defined as the ratio of the maximum capacity to minimum capacity. For example, a device with a maximum output of 10 units and a minimum output of 2 units has a turndown ratio of 5.