Search results
Results From The WOW.Com Content Network
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
The main disadvantage is the high current stress on the switch. [4] Fig. 1: Cuk converter circuit diagram. The capacitor C 1 is used to transfer energy. It is connected alternately to the input and to the output of the converter via the commutation of the transistor and the diode (see figures 2 and 3).
The residual gain is low (K = R C /R E < 1). The circuit is insensitive to the input voltage variations and the transistor stays firmly in active linear region. The input resistance is high because of the series negative feedback. The cutoff transistor breaks the connection between its input and output.
If all the input voltages are low (logical "0"), the transistor is cut-off. The pull-down resistor R 1 biases the transistor to the appropriate on-off threshold. The output is inverted since the collector-emitter voltage of transistor Q 1 is taken as output, and is high when the inputs are low. Thus, the analog resistive network and the analog ...
Subthreshold slope is used as a figure of merit for the switching efficiency of a transistor. [2] In digital circuits, subthreshold conduction is generally viewed as a parasitic leakage in a state that would ideally have no conduction. In micropower analog circuits, on the other hand, weak inversion is an efficient operating region, and ...
An analogue switch: Maxim MAX313. An analogue switch, also called a bilateral switch, is an electronic component that behaves in a similar way to a relay, but has no moving parts. The switching element is normally a pair of MOSFET transistors, one an N-channel device, the other a P-channel device. The device can conduct analog or digital ...
Diode–transistor logic (DTL) is a class of digital circuits that is the direct ancestor of transistor–transistor logic. It is called so because the logic gating functions AND and OR are performed by diode logic , while logical inversion (NOT) and amplification (providing signal restoration) is performed by a transistor (in contrast with ...
Integrated injection logic (IIL, I 2 L, or I2L) is a class of digital circuits built with multiple collector bipolar junction transistors (BJT). [1] When introduced it had speed comparable to TTL yet was almost as low power as CMOS , making it ideal for use in VLSI (and larger) integrated circuits .