When.com Web Search

  1. Ads

    related to: yukon dana 44 grizzly locker kit

Search results

  1. Results From The WOW.Com Content Network
  2. Dana 44 - Wikipedia

    en.wikipedia.org/wiki/Dana_44

    Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks. The Dana 44 was manufactured in kingpin and ball joint variations, as well as closed and open knuckle variations.

  3. Skink anti-aircraft tank - Wikipedia

    en.wikipedia.org/wiki/Skink_anti-aircraft_tank

    Tank AA, 20 mm Quad, Skink was a Canadian self-propelled anti-aircraft gun, developed in 1943–44, in response to a requirement from the First Canadian Army.Due to a lack of threat from the German Luftwaffe, the Skink was cancelled in 1944 after only three were built from Grizzly I cruisers.

  4. Dana 80 - Wikipedia

    en.wikipedia.org/wiki/Dana_80

    Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80. The Dana 80 has a GAWR up to 11,000 pounds (5,000 kg), however it is common practice among manufacturers to derate Dana 80's. Gross axle weight ratings are lowered by the vehicle ...

  5. Medium Tactical Vehicle Replacement - Wikipedia

    en.wikipedia.org/wiki/Medium_Tactical_Vehicle...

    The Medium Tactical Vehicle Replacement (MTVR) is a series of vehicles used by the U.S. Marines. [1] [9] The first MTVRs were delivered in late 1999.The MTVR is the equivalent of the U.S. Army's Family of Medium Tactical Vehicles (FMTV); the Marines do not use the FMTV (with the exception of the FMTV-based HIMARS) and the Army does not use the MTVR.

  6. Grizzly I cruiser - Wikipedia

    en.wikipedia.org/wiki/Grizzly_I_cruiser

    The Grizzly I was a Canadian-built M4A1 Sherman tank with relatively minor modifications, primarily to stowage and pioneer tool location and adding accommodations for a Number 19 radio set. They used the same General Steel hull castings as late Pressed Steel -built M4A1(75)s, to include both the standard hull and the later ones with the armour ...

  7. Dana 60 - Wikipedia

    en.wikipedia.org/wiki/Dana_60

    Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.