Search results
Results From The WOW.Com Content Network
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.
Hence, a 10 A plug will fit into all of the five types of socket outlets, a 15 A plug will fit into all except a 10 A (and so on) while a 32 A plug will fit only into a 32 A socket outlet. In general, only 10 A and 15 A socket outlets are likely to be encountered in domestic or commercial installations.
Leviton was founded in 1906 by Russian immigrants Evser Leviton and his son Isidor Leviton when they began manufacturing brass mantle tips for natural gas lights in Manhattan's Lower East Side. [ 2 ] [ 3 ] [ 4 ] In 1910, Isidor designed a screw-in lampholder for the newly invented electric light bulb and within ten years the lampholders were ...
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
The 5-pin has a design and pin layout that is identical to the 7-pin ISO 1724 connector with the exception for the lack of pin 1 (L) and pin 4 (R). This connector is sometimes present on vintage vehicles and the actual wiring may be completely different from what the standard states which means that measuring before connecting is a good idea.
In one patent, U.S. patent 774,250 a plug was used with a socket which screwed into a lampholder (like the early lampholder plugs). In the other patent U.S. patent 776,326 the same type of plug was used with various three-way adaptors that could be connected to lampholders or "a receptacle of any ordinary type". Figures 2 and 4 of this patent ...
Waferboard belongs to the subset of reconstituted wood panel products called flakeboards. [1] It is a structural material made from rectangular wood flakes of controlled length and thickness bonded together with waterproof phenolic resin under extreme heat and pressure. The layers of flakes are not oriented, which makes it easier to manufacture.
[2] [1] Kumiko panels slot together and remain in place through pressure alone, and that pressure is achieved through meticulously calculating, cutting, and arranging interweaving joints. The end-result is a complex pattern that is used primarily in the creation of shoji doors and screens. [3] Traditionally, the wood of choice was the hinoki ...