Ads
related to: radial lengths for vertical antenna
Search results
Results From The WOW.Com Content Network
For radials 9 electrical degrees or less ( 1 / 40 wavelength, each, or shorter) the effect on feedpoint impedance and the current in the mast is the same as extending the height of the antenna by a length of wire equal to 99% of the total length of all the radials, up to about a dozen radials.
Three-dimensional antenna radiation patterns. The radial distance from the origin in any direction represents the strength of radiation emitted in that direction. The top shows the directive pattern of a horn antenna, the bottom shows the omnidirectional pattern of a simple vertical dipole antenna.
Vertical polarized VHF-UHF biconical antenna 170–1100 MHz with omnidirectional H-plane pattern. Omnidirectional radiation patterns are produced by the simplest practical antennas, monopole and dipole antennas, consisting of one or two straight rod conductors on a common axis.
English: Graphs of the vertical radiation patterns of three monopole antennas of different lengths, mounted over a perfectly conducting ground. The antenna is assumed to be vertical. The graphs represent sections through the symmetrical omnidirectional pattern. The radial distance of the line from the origin at any elevation angle is ...
The vertical plane is used to plot an antenna's relative field strength perpendicular to the ground (which directly affects a station's coverage area) on a polar graph. Normally, the maximum of 1.000 or 0 dB is at the side (unless there is beam tilt ), which is labeled 0°, to 90° at the top and −90° at the bottom.
A closely related antenna is the inverted-L antenna. This is similar to the T-antenna except that the vertical feeder wire, instead of being attached to the center of the horizontal topload wires, is attached at one end. The name comes from its resemblance to an inverted letter "L" (Γ).
The G5RV antenna is a dipole antenna fed indirectly, through a carefully chosen length of 300 Ω or 450 Ω twin lead, which acts as an impedance matching network to connect (through a balun) to a standard 50 Ω coaxial transmission line. The sloper antenna is a slanted vertical dipole antenna attached to the top of a single tower. The element ...
When the antenna is fed at some other point, the formula requires a correction factor discussed below. In a receiving antenna the radiation resistance represents the source resistance of the antenna, and the portion of the received radio power consumed by the radiation resistance represents radio waves re-radiated (scattered) by the antenna. [8 ...