Search results
Results From The WOW.Com Content Network
Disk density is a capacity designation on magnetic storage, usually floppy disks. Each designation describes a set of characteristics that can affect the areal density of a disk or the efficiency of the encoded data.
Hard disk drives store data in the magnetic polarization of small patches of the surface coating on a disk. The maximum areal density is defined by the size of the magnetic particles in the surface, as well as the size of the "head" used to read and write the data. In 1956 the first hard drive, the IBM 350, had an areal density of 2,000 bit/in 2.
Cylinder, head, and sector of a hard drive. Cylinder-head-sector (CHS) is an early method for giving addresses to each physical block of data on a hard disk drive. It is a 3D-coordinate system made out of a vertical coordinate head, a horizontal (or radial) coordinate cylinder, and an angular coordinate sector. Head selects a circular surface ...
CHS was used in early MFM and RLL drives, and both it and its successor, extended cylinder-head-sector (ECHS), were used in the first ATA drives. However, current disk drives use zone bit recording, where the number of sectors per track depends on the track number. Even though the disk drive will report some CHS values as sectors per track (SPT ...
On SCSI hard disk drives, the SCSI controller can directly control spin up and spin down of the drives. Some Parallel ATA (PATA) and Serial ATA (SATA) hard disk drives support power-up in standby (PUIS): each drive does not spin up until the controller or system BIOS issues a specific command to do so. This allows the system to be set up to ...
A cycloidal drive or cycloidal speed reducer is a mechanism for reducing the speed of an input shaft by a certain ratio. Cycloidal speed reducers are capable of relatively high ratios in compact sizes with very low backlash. [1] The input shaft drives an eccentric bearing that in turn drives the cycloidal disc in an eccentric, cycloidal motion ...
In computer disk storage, a sector is a subdivision of a track on a magnetic disk or optical disc. For most disks, each sector stores a fixed amount of user-accessible data, traditionally 512 bytes for hard disk drives (HDDs), and 2048 bytes for CD-ROMs , DVD-ROMs and BD-ROMs . [ 1 ]
Comparison of several forms of disk storage showing tracks (not-to-scale); green denotes start and red denotes end. * Some CD-R(W) and DVD-R(W)/DVD+R(W) recorders operate in ZCLV, CAA or CAV modes. Mechanically there are two different motions occurring inside the drive. One is the rotation of the disks inside the device.