Ad
related to: th400 transmission gear ratios explained
Search results
Results From The WOW.Com Content Network
Turbo-Hydramatic or Turbo Hydra-Matic is the registered tradename for a family of automatic transmissions developed and produced by General Motors.These transmissions mate a three-element turbine torque converter to a Simpson planetary geartrain, providing three forward speeds plus reverse.
Also found in wide and narrow ratio configurations. Muncie SM319 transmission — 3-speed transmission physically identical to the Muncie SM318, with an added Borg Warner overdrive unit. Muncie SM420 transmission — 4-speed manual used up to 1967, very similar to sm 465 except small changes to gear ratios and location of reverse.
The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
After its introduction in 1984, the Justy was also available with 4WD and thus a different gearbox. The gear ratios for this gearbox were altered slightly. In 1994 the normal/FWD gearbox was dropped; one could only get a 4WD gearbox by then. Gear ratios: 1st 3.071 2nd 1.695 3rd 1.137 4th .771 5th .631, Rev 3.461 Final 5.200
Final drive ratios include 3.63, 3.29, 3.05, and 3.91. This same transmission is used in the Saturn Vue Green Line hybrid vehicle with the addition of an auxiliary oil pump and hybrid-aware electronics. It is designed for 3.0–3.5 L engines producing up to 205 ft·lbf (278 N·m) of torque, but was also commonly mated to some versions of GM's 4 ...
The Ford–GM 10-speed automatic transmission is part of a joint venture between Ford Motor Company and General Motors to design and engineer two transmissions: a longitudinal 10-speed transmission and a transverse 9-speed trans-axle. Each company manufactures its own unique version of the transmissions in its own factories.
Because it was based on the "X" transmissions, its gear ratios from 1-3 were the same, with the fourth being 0.67:1. The transmission featured a split-torque application for third gear as well as a lockup in the torque converter. The XT-LOD was initially abandoned in 1966, but the design began again in 1974 because of rising gas prices.
Fourth range the coupling fills, releasing the front clutch makes a ratio of 1 to 1. This transmission, like single and dual range and dual coupling hydramatics, also has the feature of split torque in the transmission, whereby in fourth (or high) gear only 40% to 50% depending on transmission—40% in Roto's case—but because of the design ...