Search results
Results From The WOW.Com Content Network
This article gives a list of conversion factors for several ... ≡ 0.3048 m ≡ 1 ⁄ 3 yd ≡ 12 inches ≡ 0.3048 m ... Currently defined in US as 3 Statute miles ...
ftin (feet/inches) ft m (foot m) hand: hand h 1.0 h (4 in; 10 cm) inch: in in Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 in (25 mm) in cm; in mm; Maritime units: nautical mile: nmi nmi the international standard nautical mile 1.0 nmi (1.9 km; 1.2 mi) nautical mile: oldUKnmi (admiralty nmi) nmi 6080 ft the pre-1970 ...
The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units. {{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in ...
Historically, a wide range of units was used for the same type of quantity. In different contexts length was measured in inches, feet, yards, fathoms, rods, chains, furlongs, miles, nautical miles, stadia, leagues, with conversion factors that were not based on power of ten.
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
Toyota Tundra. Starting Price: $38,000 Chance of Lasting 250,000+ Miles: 36.6% Topping the iSeeCars 2024 Study of the Top 30 Vehicles Most Likely to Last 250,000+ Miles is the Toyota Tundra. Known ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
[2] [3] There were two factors that influenced the order: for one, the imperial standard yard of 1855 had been found to be unstable and shortening by measurable amounts. Secondly, the United States was a co-signee of the Treaty of the Metre of 1875 and had received two meter prototypes on which to base a new fundamental standard.