Search results
Results From The WOW.Com Content Network
The following is a list of 7400-series digital logic integrated circuits. ... 3-3-2-2-input AND-OR expander for 74x50, 74x53, 74x55 ... 3-to-8 line decoder ...
In digital electronics, a binary decoder is a combinational logic circuit that converts binary information from the n coded inputs to a maximum of 2 n unique outputs. They are used in a wide variety of applications, including instruction decoding, data multiplexing and data demultiplexing, seven segment displays, and as address decoders for memory and port-mapped I/O.
The following 4-to-1 multiplexer is constructed from 3-state buffers and AND gates (the AND gates are acting as the decoder): A 4:1 MUX circuit using 3 input AND and other gates. The subscripts on the inputs indicate the decimal value of the binary control inputs at which that input is let through.
The following is a list of CMOS 4000-series digital logic integrated circuits.In 1968, the original 4000-series was introduced by RCA.Although more recent parts are considerably faster, the 4000 devices operate over a wide power supply range (3V to 18V recommended range for "B" series) and are well suited to unregulated battery powered applications and interfacing with sensitive analogue ...
An entire processor can be created using NOR gates alone. The original Apollo Guidance Computer used 4,100 integrated circuits (IC), each one containing only two 3-input NOR gates. [3] As NAND gates are also functionally complete, if no specific NOR gates are available, one can be made from NAND gates using NAND logic. [2]
The gate delay can easily be calculated by inspection of the full adder circuit. Each full adder requires three levels of logic. In a 32-bit ripple-carry adder, there are 32 full adders, so the critical path (worst case) delay is 3 (from input to carry in first adder) + 31 × 2 (for carry propagation in latter adders) = 65 gate delays. [6]
For example, when used as an address decoder, the 74154 [3] provides four address inputs and sixteen (i.e., 2 4) device selector outputs. An address decoder is a particular use of a binary decoder circuit known as a "demultiplexer" or "demux" (the 74154 is commonly called a "4-to-16 demultiplexer"), which has many other uses besides address ...
A truth table of a single bit 4-to-2 priority encoder is shown, where the inputs are shown in decreasing order of priority left-to-right, and "x" indicates a don't care term - i.e. any input value there yields the same output since it is superseded by a higher-priority input. The (usually-included [a]) "v" output indicates if the input is valid.