Search results
Results From The WOW.Com Content Network
A compression ratio of 2 is possible (and sometimes more) but unless the motive steam is at a reasonably high pressure (say, 16 bar g - 250 psig - or more), the motive steam consumption will be in the range of 2 kg per kg of suction vapors. A higher compression ratio means a smaller heat exchanger, and a reduced investment cost.
Purified steam relies on a combination of filtration, deionized water, controlled steam generation and a selective membrane process to deliver ultra high purity steam to process. The selective membrane process solves many of the challenges for direct delivery of water vapor by changing the way water molecules are converted from liquid to gas phase.
Steam and water analysis system (SWAS) [1] is a system dedicated to the analysis of steam or water. In power stations , it is usually used to analyze boiler steam and water to ensure the water used to generate electricity is clean from impurities which can cause corrosion to any metallic surface, such as in boiler and turbine .
The heated water/steam mixture then rises into the steam drum. Here, saturated steam is drawn off the top of the drum. In some [which?] services, the steam passes through tubes in the hot gas path, (a superheater) to become superheated. Superheated steam is a dry gas and therefore is typically used to drive turbines, since water droplets can ...
The water is heated and then routed into a reduced-pressure flash evaporation "stage" where some of the water flashes into steam. This steam is subsequently condensed into salt-free water. The residual salty liquid from that first stage is introduced into a second flash evaporation stage at a pressure lower than the first stage pressure.
The specific heat of the human body calculated from the measured values of individual tissues is 2.98 kJ · kg−1 · °C−1. This is 17% lower than the earlier wider used one based on non measured values of 3.47 kJ · kg−1· °C−1.
Stream power is the rate of energy dissipation against the bed and banks of a river or stream per unit downstream length. It is given by the equation: = where Ω is the stream power, ρ is the density of water (1000 kg/m 3), g is acceleration due to gravity (9.8 m/s 2), Q is discharge (m 3 /s), and S is the channel slope.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...