Ads
related to: thin brick veneer for fireplace
Search results
Results From The WOW.Com Content Network
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
Flexible stone veneer is made from a thin layer of stone stripped or peeled from a metamorphic stone marble chips or slab, rather than cutting from a solid stone or precast composite material. Thin veneers (from .5mm to 2mm thick) of slate, schist, or sandstone ( metamorphic rocks ) are pulled away from the original thicker stone slabs by ...
The utilization of thin stone veneer for complete facades of buildings popped up in the 1940s. Stone veneer construction became much of what we see today in the 1950s. Transportation improved, so stone veneer was transported more efficiently and at lower costs than ever before. Methods to attach veneer to steel were developed; diamond-bladed ...
Tile is a thin modular stone unit, commonly 12 inches (300 mm) square and 3 ⁄ 8 inch (9.5 mm) deep. Other popular sizes are 15 inches (380 mm) square, 18 inches (460 mm) square, and 24 inches (610 mm) square; these will usually be deeper than the 12-inch square.
In this context, the brick masonry is primarily decorative, not structural. The brick veneer is generally connected to the structural wall by brick ties (metal strips that are attached to the structural wall, as well as the mortar joints of the brick veneer). There is typically an air gap between the brick veneer and the structural wall.
Thin – brick with normal height and length but thin width to be used as a veneer; Specialized use bricks: Chemically resistant – bricks made with resistance to chemical reactions Acid brick – acid resistant bricks; Engineering – a type of hard, dense, brick used where strength, low water porosity or acid (flue gas) resistance are needed ...