Search results
Results From The WOW.Com Content Network
induction motors [24] synchronous motors with permanent magnets or DC wound rotor; switched reluctance motors; In such device, dynamic electromagnetic forces come from variations of magnetic field, which either comes from a steady AC winding or a rotating DC field source (permanent magnet or DC winding).
The rotor is made of permanent magnet. Small synchronous motor with integral stepdown gear from a microwave oven. A synchronous electric motor is an AC electric motor in which, at steady state, [1] the rotation of the shaft is synchronized with the frequency of the supply current; the rotation period is exactly equal to an integer number of AC ...
A permanent magnet motor is a type of electric motor that uses permanent magnets for the field excitation and a wound armature. The permanent magnets can either be stationary or rotating; interior or exterior to the armature for a radial flux machine or layered with the armature for an axial flux topology.
The motor from a 3.5 in floppy disk drive. The coils, arranged radially, are made from copper wire coated with blue insulation. The rotor (upper right) has been removed and turned upside-down. The gray ring inside its cup is a permanent magnet. This particular motor is an outrunner, with the stator inside the rotor. DC brushless ducted fan. The ...
The specific problem is: make accessible to the ordinary reader. ... have no noise, and may slip without damage. ... “Permanent Magnet and Electromechanical Devices ...
The primary design factors of a high efficiency glandless circulating pump include an electronically commutated synchronous motor, a permanent magnet rotor, and canned rotor technology. An electronically commutated synchronous motor is used to convert the energy current from a DC energy source into an AC current which is supplied to the drive ...
DTC techniques for the interior permanent magnet synchronous machine (IPMSM) were introduced in the late 1990s [16] and synchronous reluctance motors (SynRM) in the 2010s. [17] DTC was applied to doubly fed machine control in the early 2000s. [18] Doubly fed generators are commonly used in 1-3 MW wind turbine applications.
The synchronous reactances are exhibited by the armature in the steady-state operation of the machine. [8] The three-phase system is viewed as a superposition of two: the direct one, where the maximum of the phase current is reached when the pole is oriented towards the winding and the quadrature one, that is 90° offset.