Ads
related to: serpentine timing belt diagram
Search results
Results From The WOW.Com Content Network
The 1962 Glas 1004 was the first mass-produced vehicle to use a timing belt. The 1966 Pontiac OHC Six engine was the first US mass-produced vehicle to use a timing belt, [21] [22] while the 1966 Fiat Twin Cam engine was the first mass-produced engine to use a timing belt with twin camshafts. Carmakers began to adopt timing belts in the 1970s ...
Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...
Belt tensions should also be adjusted to belt type, size, speed, and pulley diameters. Belt tension is determined by measuring the force to deflect the belt a given distance per inch (or mm) of pulley. Timing belts need only adequate tension to keep the belt in contact with the pulley.
A toothed belt, timing belt, cogged belt, cog belt, or synchronous belt is a flexible belt with teeth moulded onto its inner surface. Toothed belts are usually designed to run over matching toothed pulleys or sprockets. Toothed belts are used in a wide array of mechanical devices where high power transmission is desired.
From 1987 onwards, the LB4's output was 160 hp (119 kW) for pickups, while full-size vans were rated at 150 hp (112 kW). In 1988, the S-10/S-15 trucks, S-10 Blazer, and S-15 Jimmy had the LB4 4.3 L (262 cu in) as an available option (the accessory drive was upgraded to a serpentine belt drive), which later replaced the 2.8L as the base V6.
Four wool spinning machines driven by belts from an overhead lineshaft (Leipzig, Germany, circa 1925) The belt drives of the Mueller Mill, model and reality, in motionA line shaft is a power-driven rotating shaft for power transmission that was used extensively from the Industrial Revolution until the early 20th century.
It replaced the hemp and rope belt used on automobiles and industrial machinery at the time, and was a model for the common serpentine belt. The belt's success propelled the company to become the largest manufacturer of V-belts, a title it still holds. [2] [3] In 1919, the International Rubber Company changed its name to the Gates Rubber Company.
A timing mark is an indicator used for setting the timing of the ignition system of an engine, typically found on the crankshaft pulley (as pictured) or the flywheel. [1] These have the largest radius rotating at crankshaft speed and therefore are the place where marks at one degree intervals will be farthest apart.