Search results
Results From The WOW.Com Content Network
2.4 GHz helical antenna radiation pattern (NEC simulation) The Numerical Electromagnetics Code , or NEC , is a popular antenna modeling computer program for wire and surface antennas . It was originally written in FORTRAN during the 1970s by Gerald Burke and Andrew Poggio of the Lawrence Livermore National Laboratory .
10 MHz – 8 GHz (planned modules for 9 kHz – 26 GHz; 9 kHz – 55 GHz, and 9 kHz – 70 GHz) Up to 490 MHz (2 Rx with 245 MHz each) 16 14 Yes 2 GSPS 0.005 (OCXO option) 2/1/3 Embedded or True IQ data via 1 x or 2 x USB 3.0. Optional 1 x USB 3.1 GEN2 (power only). Internet remote via HTTP / JSON Yes Yes No 1 x XC7A200T-2 (930 GMACs)
Typically a transmitter design includes generation of a carrier signal, which is normally [3] sinusoidal, optionally one or more frequency multiplication stages, a modulator, a power amplifier, and a filter and matching network to connect to an antenna. A very simple transmitter might contain only a continuously running oscillator coupled to ...
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...
Software-defined radio (SDR) is a radio communication system where components that conventionally have been implemented in analog hardware (e.g. mixers, filters, amplifiers, modulators/demodulators, detectors, etc.) are instead implemented by means of software on a computer or embedded system. [1]
4×4 array of 2.4 GHz patch antenna elements Patch antenna gain pattern. A patch antenna is a type of antenna with a low profile, usually consisting of a printed circuit board. It consists of a planar rectangular or circular sheet or "patch" of metal, mounted over a larger sheet of metal called a ground plane.
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The loss in that feed line is 3.2 dB at 1 GHz; approximately 5 dB at the GPS frequency (1.575 42 GHz). This feed line loss can be avoided by placing an LNA at the antenna, which supplies enough gain to offset the loss. An LNA is a key component at the front-end of a radio receiver circuit to help reduce unwanted noise in particular.