Search results
Results From The WOW.Com Content Network
Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput. When a router or switch is configured to use excessively large buffers, even very high-speed networks can become practically unusable for many interactive applications like voice over IP (VoIP), audio streaming , online ...
Instantaneous packet delay variation is the difference between successive packets—here RFC 3393 does specify the selection criteria—and this is usually what is loosely termed "jitter", although jitter is also sometimes the term used for the variance of the packet delay. As an example, say packets are transmitted every 20 ms.
Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...
Network congestion in data networking and queueing theory is the reduced quality of service that occurs when a network node or link is carrying more data than it can handle. . Typical effects include queueing delay, packet loss or the blocking of new connectio
The amount of packet loss that is acceptable depends on the type of data being sent. For example, for voice over IP traffic, one commentator reckoned that "[m]issing one or two packets every now and then will not affect the quality of the conversation. Losses between 5% and 10% of the total packet stream will affect the quality significantly."
A physical Wake-on-LAN connector (white object in foreground) featured on the IBM PCI Token-Ring Adapter 2. Wake-on-LAN (WoL or WOL) [a] is an Ethernet or Token Ring computer networking standard that allows a computer to be turned on or awakened from sleep mode by a network message.
The dominant equation here is the Shannon–Hartley theorem, and analog limitations of this type can be understood as factors that affect either the analog bandwidth of a signal or as factors that affect the signal-to-noise ratio. The bandwidth of wired systems can be in fact surprisingly narrow, with the bandwidth of Ethernet wire limited to ...