Ads
related to: fixing an oversized plug hole in wood wall molding ideas
Search results
Results From The WOW.Com Content Network
TIME-SERT insert. A threaded insert, also known as a threaded bushing, is a fastener element that is inserted into an object to add a threaded hole. [1] They may be used to repair a stripped threaded hole, provide a durable threaded hole in a soft material, place a thread on a material too thin to accept it, mold or cast threads into a work piece thereby eliminating a machining operation, or ...
Before commercial wall plugs, fixings were made to brick or masonry walls by first chiselling a groove into a soft mortar joint, hammering in a crude wooden plug and then attaching to the wooden plug. This was time consuming and required a large hole, thus more patching of the wall afterwards. It also limited the holes' location to the mortar ...
Also called coving or spelled molding. A strip of material with various profiles used to cover transitions between surfaces or for decoration. moulding plane. Also spelled molding plane. mortise. Also spelled mortice. A cavity or hole, generally rectangular, in a piece of wood, meant to receive a tenon or a hinge. mitre. Also spelled miter.
For premium support please call: 800-290-4726 more ways to reach us
Bed-mould or bed moulding: Narrow moulding used at the junction of a wall and ceiling, found under the cornice, of which it is a part. [2] Similar to crown moulding, a bed mould is used to cover the joint between the ceiling and wall. Bed moulds can be either sprung or plain, or flush to the wall as an extension of a cornice mould. [3]
Crown moulding (interchangeably spelled Crown molding in American English) is a form of cornice created out of decorative moulding installed atop an interior wall. It is also used atop doors, windows, pilasters and cabinets .
The staff bead, a 1-inch dowel with approx 1 ⁄ 3 shaved off the back, is set on the external corner by the joiner on site, fastened to wooden plugs set into the brick/block seams, or to the wood frame. Plaster is run up to the staff bead and then cut back locally to the bead or "quirked" to avoid a weak feather edge where the plaster meets ...
Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...