Search results
Results From The WOW.Com Content Network
The Tiger had 60 mm (2.4 in) thick hull side plates and 80 mm (3.1 in) armour on the side superstructure/sponsons, while turret sides and rear were 80 mm. The top and bottom armour was 25 mm (1 in) thick; from March 1944, the turret roof was thickened to 40 mm (1.6 in). [7] Armour plates were mostly flat, with interlocking construction.
The designation "L/56" means the barrel is 56 times 88 mm - about 4.9 m (16 ft 1 in). The longer the tube is in relation to its bore, the higher the muzzle velocity it can generate on fixed charge. A longer gun barrel allows the expanding gas from the shell's charge to act on the projectile longer than a short barrel, imparting it more velocity ...
By this time, supporting Churchill tanks had arrived and a shot by a Churchill from either the 142nd Regiment RAC or 48 RTR jammed the turret, forcing the Tiger crew to abandon their tank. Photographic and documentary evidence corroborated Oscroft's story, proving that Tiger 131 was the tank disabled at Point 174 on 24 April 1943 and not the ...
The VK 45.01 (P), also informally known as Tiger (P) or Porsche Tiger, was a heavy tank prototype designed by Porsche in Germany.With a dual engine gasoline-electric drive that was complex and requiring significant amounts of copper, it lost out to its Henschel competitor on trials, it was not selected for mass production and the Henschel design was produced as the Tiger I.
The Schmalturm had a much narrower front face of 120 mm (4.7 in) armour sloped at 20 degrees; side turret armour was increased to 60 mm (2.4 in) from 45 mm (1.8 in); roof turret armour increased to 40 mm (1.6 in) from 16 mm (0.63 in); and a bell shaped gun mantlet similar to that of the Tiger II was used.
Prior to the outbreak of World War II most of the twin turret tanks were converted to single turret versions and only 24 twin-turret types remained in Polish service (as opposed to roughly 108 of the other type). Twin and single turret variants had no specific designations. In some modern books they are unofficially designated "7TP dw." and ...
The Nebelwurfgerät was mounted in two sets of three, one on each forward side wall of the turret [1] with each launcher being 9 centimetres (3.5 in) in calibre by 15 centimetres (6 in) in length. The uppermost launcher tubes were oriented forward and angled slightly outwards while the middle and lower tubes were set on a progressively lower ...
Tests of production M1 guns revealed that the gun with its counterweight also had issues with binding when trying to rotate the turret when the tank was resting at a steep angle. An 800 lb (360 kg) storage box was added to the turret rear to improve balance, [1] with evaluations held in early 1943 and the final report tendered in April 1943. [13]